End of Material Sensor (Electro-mechanical) Sensors Indicators Operation indicator (Orange LED)

Indicators Operation indicator (Orange LED) Protection circuits Output reverse polarity protection

Functions OFF-delay timer 0 to 40 ms (1 to 20 ms: 1-ms increments

It is powered by two 9-Volt batteries (not included)

in-house standards: oil-resistant Case Material Nickel plated brass Clamping Nut Nickel plated brass Toothed Washer Zinc plated steel Sensing surface material PBT Cable Polyvinyl chloride (PVC)

The HD19 PCB Kit is a PC board designed to go in an end user-provided

End of Material Sensor (Electro-mechanical) Sensors Indicators Operation indicator (Orange LED)The End of Material sensor is designed for metal stamping applications. It detects material run out, and prevents pulling of the coil end through the feeder or straightener. It also keeps the press from running without coil stock. The sensor is typically installed so that the arm rides on the material. When the material runs out, the arm drops onto the insulated pin below it, generating a ground signal that is detected by the die protection