CM Jumper (R7) Chain Bags This Block secures the Loose

This Block secures the Loose End Chain in Classic & Next-Gen Lodestar Large Frame Hoists

This part is for all Next-Gen and Classic Lodestar Small Frame Hoists (Model B

This Bearing gets installed on the Gear Side of the Lift Wheel for all Classic Lodestar Large Frame Hoists

the Stator that is compatible with this Rotor Assembly

Vertical Load Capacity: 5

CM Jumper (R7) Chain Bags This Block secures the LooseThis is a replacement jumper wire that is used is many contactor configurations for Next Gen Lodestar hoists. If you are not sure which jumpers are required in the contactor of your hoist, you can use our Parts Diagrams or check the CM Next Gen Lodestar Service Manual.